bort medical Generation Rodillera Manual Del Usuario página 9

– do not make any changes to the product
– do not wear it on open wounds
– do not use in case of intolerance of one of the materials used
– no re­use – this medical aid is intended for treating one patient
– whilst wearing the support, please neither use any creams nor ointments
on or around it as they can destroy the material
Fitting instructions
Before fitting the latch plates on the thigh and for REF 114 490 G, open the
additional sealing tape.
1
Open the velour fastening on the knee support thigh. The Generation
Knee Support Plus (REF 114 490 G) has an additional circumferential
harness, please also open it. If required, the harness can be unthreaded. The
joint straps should always be located on the outer side of the leg.
2
Pull the knee support as far as possible over the knee so that the
silicone pad encloses the kneecap.
3
The Generation Knee Support Plus (REF 114 490 G) additionally has a
circumferential harness, please guide it through the guide loops and fix
it. The joint straps should always be located on the outer side of the leg.
Finally, check the fit and correct positioning of the knee support, so that the
support supports and compresses but doesn't constrict.
Removal
To remove the support, open the sealing tape (only for the Generation Knee
Support Plus REF 114 490 G) and the latch plates on the thigh, grasp the
lower edge of the support at the side in the vicinity of the splints and pull it
down over the foot.
EN
09