Mark BLINDER 8001 Instrucciones De Uso

audiovias.com
IMPORTANT NOTES
Minimum distance from a lighted object is 1 Metre.
Maximum rated ambient temperature is 45°C.
Input cable may be subjected to temperatures up to 180°C.
Maximum rated voltage is 240V.
Normal frequency is 50/60 Hertz.
Maximum rated wattage is 650 Watts per lamp.
SAFETY NOTES
Replace lamp if cracked or thermally deformed.
The Spot Banks should not be used in explosive or inflammable
environments.
Always fit safety wire from luminaire to supporting framework.
Do not over voltage luminaire.
When connecting to the electrical supply, ensure that the luminaire
is effectively earthed, that the supply is at the rated voltage for the
lamp, wiring is complete and as shown on the diagram below and
that the correct polarity is observed.
If the external flexible cable or cord of this luminaire is damaged, it
shall be exclusively replaced by the manufacturer or his service agent
or a similar qualified person in order to avoid a hazard.
Shields, lenses or ultraviolet screens shall be changed if they have
become visibly damaged to filch an extent that their effectiveness is
impaired, for example by cracks or deep screeches.
Always disconnect from the mains, when the device is not in user or
before cleaning it.
ELECTRICAL CONNECTION
WARNING - This appliance MUST be earthed.
The supply cables should be connected to an approved plug in accordance
with following code:
Wire Colour Connection
Green & Yellow Earth
Blue Neutral
Brown Live
LAMP REPLACEMENT (see Fig 1.)
1) Disconnect the luminaire from the power supply and allow cooling.
2) Undo the 2 screws that hold each lamp-retaining ring that holds the Par lamp.
3) Remove wires from the lamp by unscrewing the screw terminals.
4) To refit lamp, follow steps 1 to 3 in reverse order.
5) Ensure the lamp is seated properly and make sure no wires are trapped before refixing.
MOUNTING AND ADJUSTMENT
WARNING-Max Temp=180°C - This luminaire is not suitable for mounting on flammable surfaces.
The luminaire is supplied with a yoke with a 12.7mm diameter hole allowing the luminaire to be fitted with a hook clamps in order that it can be mounted
on a 5cm tube. Using the "T" bar on the side, the tilt angle can be adjusted.
LAMP TYPES
Standard lamp types are shown in the box below.
N.B. Always use bulbs of identical Voltage and Wattage in the same circuit.
BLINDER 8001
Plug Terminal Marking or Colour
E Green & Yellow or
N Black
L Red
Lamp types for Par 36 Spot Bank
Type Voltage
DWE PAR36 120v
GE-4596 28v
This symbol on the product or on its packaging indicates that this product
shall not be trated as household waste. Instead it shall be handed over to
the applicable collection point for the recycling of electrical an electronic
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste handling
of this product. The recycling of amterials will help to conserve natural
resources. For more detailed information sabout recycling of this product,
please contact your local city office, your household waste disposal service
or the shop where you purchased the product.
User Manual/Manual de uso
BLINDER 8001 Spot Bank
Operating Instructions
WARNING - This luminaire is intended for professional use only
and does not comply with certain domestic lighting regulations.
LAMP RETAINING RING
(safety mesh)
RETAINING SCREW
LAMP
TERMINAL
Wattage
650w
250w
www.audiovias.com
BLINDER 8001
Ver. 12.05.01
Pag 1
YOKE