LG LSC22991ST Manual Del Propietário página 25

It is essential that the manufacturer's recommended installation, maintenance and filter
replacement requirements be carried out for the product to perform as advertised.
NOTE
While the testing was performed under standard laboratory conditions, actual
•
performance may vary.
Replacement Cartridge: ADQ73613401
For estimated costs of replacement elements please call 1-877-714-7486 or visit our
website at www.lge.com
To reduce the risk associated with choking:
WARNING
Do not allow children under 3 years of age to have access to small parts during the
•
installation of this product.
To reduce the risk associated with the ingestion of contaminants:
Do not use with water that is microbiologically unsafe or of unknown quality without
•
adequate disinfection before or after the system. Systems certified for cyst reduction
may be used on disinfected water that may contain filterable cysts. EPA Establishment
# 070595-MEX-001
To reduce the risk associated with property damage due to water leakage:
CAUTION
Read and follow. Use Instructions before installation and use of this system.
•
Installation and use MUST comply with all state and local plumbing codes.
•
Do not install if water pressure exceeds 120 psi (827 kPa). If your water pressure
•
exceeds 80 psi, you must install a pressure limiting valve. Contact a plumbing
professional if you are uncertain how to check your water pressure.
Do not install where water hammer conditions may occur. If water hammer conditions
•
exist you must install a water hammer arrester. Contact a plumbing professional if you
uncertain how to check for this condition.
Do not install on hot water supply lines.
•
The maximum operating water temperature of this filter system is 100°F (37.8°C).
Protect filter from freezing. Drain filter when temperatures drop below 40°F (4.4°C).
•
The disposable filter cartridge MUST be replaced every 6 months, at the rated capacity
•
or if a noticeable reduction in flow rate occurs.
Protect from freezing, remove filter cartridge when temperatures are expected to drop
•
below 33° F.
Do not install systems in areas where ambient temperatures may go above
•
110° F (43.3° C).
Where a backflow prevention device is installed on a water system, a device for
•
controlling pressure due to thermal expansion must be installed.
Ensure all tubing and fittings are secure and free of leaks.
•
Manufactured for LG Electronics by MCM Co.,Ltd. 45-10. Nowon-Ri, Yiwol-Myun,
Jinchun-Kun, Chung-Buk, Korea
24
Operation