Programming The Remote Control - Kohler K-1703 Guia Del Usuario

FCC Compliance (cont.)
interference that may cause undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party
responsible for compliance could void the users authority to operate
the equipment.

Programming the Remote Control

NOTE: Programming of the remote control is normally not required.
If more than one device in your home, or in the near vicinity of
your home, uses a remote control, it may be necessary to program
this remote control to the user keypad. If you replace your remote
control, or replace the pump control, it may be necessary to program
the remote control.
Turn the whirlpool power on.
Turn off all modes of operation. Wait approximately one minute
until the keypad darkens completely.
On the user keypad, press the up arrow, down arrow and the
"OK" button simultaneously. The bottom LED, on the keypads
indicator bar, will begin flashing.
While the LED is flashing, press the "OK" button on the keypad.
A light sequence will illuminate up and down the indicator bar.
While the indicator bar light sequence is active, press any button
on the remote control. The program will download and the user
keypad will darken. The user keypad will now respond only to
this remote control.
Cleaning Your Remote
Use a soft cloth to wipe the remote control after each use. If the
surface becomes dirty, use a non-abrasive soap and warm water
to clean.
Limited One-Year Warranty
For the U.S.A. and Canada Only
KOHLER plumbing fixtures, faucets and fittings are warranted to be
®
free of defects in material and workmanship for one year from date of
installation.
Kohler Co. will, at its election, repair, replace or make appropriate
adjustment where Kohler Co. inspection discloses any such defects
1021550-5-B 4 Kohler Co.