Aquaguard AG-9100 Guia De Inicio Rapido

Work Safe, READ THIS!
ATTENTION: FAILURE TO READ AND COMPLY WITH ALL WARNINGS, CAUTIONS AND INSTRUCTIONS PRIOR TO STARTING INSTALLATION MAY
CAUSE PERSONAL INJURY AND/OR PROPERTY DAMAGE AND VOID WARRANTY.
STOP/READ: This device must be installed in accordance with manufacturer's instructions. This unit must be in accordance with all applicable local plumbing, drainage and
electrical codes.
WARNING: Remove electrical shock hazard – DISCONNECT THE POWER BEFORE INSTALLING to avoid electrical shock and/or equipment damage. Do not use on
circuits exceeding 6-32 volts DC or 12-24 volts AC to avoid damage.
AquaGuard
This is an approved
switches, and AG-5100. See specific product installation instructions for AG-9100 wiring diagram or visit www.rctus.com for wiring diagrams.
AquaGuard
INSTALLATION OF
(To ensure proper performance of product, instructions must be followed.)
MOUNTING THE AG-9100 REMOTE ALARM:
1. Disconnect all power to driving device at main panel.
2. Determine the best mounting location of the alarm so that the alarm can be both visually seen and audibly heard. The AG-9100 Remote Alarm can be mounted on a
vertical wall, on a ceiling, or on any outside surface of a hot water tank or air handler unit. Additional 24 gauge, 2 conductor wire (not supplied) may be required to
connect to the driving device. For a clean, professional installation, the AG-9100 Remote Alarm can be wired with "through hole" wiring to conceal unsightly wires.
3. Mounting options on the AG-9100 Remote Alarm are shown in figures 2 and 3 and are as follows: 2 sided adhesive tape, 2 each #4 pan head or flat head screws, or 2
each #6 pan head or flat head screws. If you are mounting the alarm using "through hole" wiring, drill a 1/4" diameter hole at the mounting location (see figure 2).
Feed wire from driving device through the newly drilled hole. If additional wire length is required, splice the additional wire to the wire of the alarm. Polarity is not
required. The drilled hole for wire clearance may need to be larger if wire nuts are used to splice the two wires.
(fig.1)
Switch shown in OFF position
WIRING THE AG-9100:
(To ensure proper performance of product, instructions must be followed.)
1. Ensure the power is disconnected to the
instructions for wire diagrams.
2. The AG-9100 Remote Alarm can only be connected to devices that have an input voltage range of 6-32 VDC or 12-24 VAC.
AquaGuard
®
3. For all
wire to the Transformer Common wire of the HVAC unit.
4. Wiring instructions for driving devices other than
TESTING THE AG-9100:
AquaGuard
1. With power to
alarm should sound intermittently. If LED lights flash and there is no audible alarm, move slide switch to the opposite position and test again.
Installation Instructions:
®
product that can be used with the following
®
AG-9100 REMOTE ALARM:
Through hole wire mounting
AquaGuard
®
water sensing switch or driving device. Refer to the specific
Water Sensing Systems switches, connect the plain White wire to the Normally Open wire of the switch. Connect the White with Red Stripe
AquaGuard
®
water sensing switch (or other driving device) on, activate the switch to simulate water being sensed. LED lights should flash and
AquaGuard
®
(fig. 2)
®
,
please refer to the installation instructions included with that device.
devices: All 3 wire magnetic switches, all 4 wire electronic
(fig. 3)
Flush wire mounting
AquaGuard
AG-9100
®
product installation