Publicidad
Idiomas disponibles
Idiomas disponibles
RECOMMENDED MATERIALS AND TOOLS FOR INSTALLATION
• Carpenter Level
• Tube of Sealant
INSTALLING YOUR DROP-IN BOWL
1. Place the drop-in bowl into the hole to verify it is the correct size.
2. Make sure the bowl is level and seated in the desired position by using a carpenter level.
Remove the bowl from the hole.
NOTE: Practice the proper insertion two or three times before applying the sealant.
3. Place the bowl onto a soft surface to avoid scratches and install the faucet according to the
manufacturer's instructions.
DO NOT OVERTIGHTEN THE NUT ONTO THE BOWL.
4. Turn the bowl upside down making certain the surface to be sealed is clean, dry, free of
soap, oil, and grease. Apply a layer of sealant onto the rim.
5. Lift the bowl, turn it over and gently lower it into the hole. Wipe excess sealant with a clean,
damp cloth, leaving a smooth and evenly beveled edge around the bowl. If there is a gap, apply
more sealant immediately and remove any excess.
6. Allow four hours curing time (drying time) before connecting the fittings to the supply lines
and the drain. Not allowing the proper curing time may cause the bowl to shift from its original
position.
CAUTION
SEVERE DAMAGE MAY OCCUR.
Publicidad
