Troubleshooting - Black and Decker MS2000 Manual De Instrucciones

Lijadora multiuso smart select

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

cleaner because sparks are generated. Wear safety glasses and a dust mask. Due to the

danger of fire, do not use your sander to sand magnesium surfaces. Do not use for wet

sanding.

Dust canister - Figure L

Attaching and removing:

• Fit the dust canister over the dust extraction

outlet. To remove the canister, pull it out to the

rear and off the outlet.

Emptying:

• Remove canister and shake out debris over a

trash can.

Hints for optimum use

• For user comfort, the tool can be operated with

one hand or two as shown in figure M. Do not

place your hands over the ventilation slots.

• Do not exert too much pressure on the tool.

• Regularly check the condition of the sanding

sheet. Replace when necessary.

• Always sand with the grain of the wood.

• When sanding new layers of paint before

applying another layer, use extra fine grit.

• On very uneven surfaces, or when removing

layers of paint, start with a coarse grit. On other

surfaces, start with a medium grit. In both

cases, gradually change to a fine grit for a

smooth finish.

Maintenance

Your tool has been designed to operate over a long period of time with a minimum of

maintenance.

Continuous satisfactory operation depends upon proper tool care and regular cleaning.

• Clear the cooling vents and slots with a clean, dry paint brush.

• Clean the housing with a clean, damp cloth. Do not use solvents.

Accessories

Recommended accessories for use with your tool are available at extra cost from your

local dealer or authorized service center. If you need assistance in locating any

accessory for your tool, please call 1-800-54-HOW-TO (544-6986).

WARNING: The use of any accessory not recommended for use with this tool could be

hazardous.

Problem

Possible Cause

• Unit will not start.

• Cord not plugged in.

• Circuit fuse is blown.

• Replace circuit fuse.