Taurus Alpatec Manual Del Usuario página 11

SERVICE:
- Make sure that the appliance is serviced only
by specialist personnel, and that only original
spare parts or accessories are used to replace
existing parts/accessories.
appliance's cleaning is not done according to
these instructions.
- Any misuse or failure to follow the instruc-
tions for use renders the guarantee and the
manufacturer's liability null and void.
DESCRIPTION
A Air outlet
B On/Of switch
C Control panel
D Top wall bracket
E L-shape
F Plastic expansion screw
G Wall screws
H
PANEL DE CONTROL / MANDO A DISTANCIA
a On/Off button
b Intensity off lame button
c Low heating power button
d High heating power button
e On/Off pilot light
f Flame pitot light
g Low powe pilot light
h High power pilot light
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
INSTALLATION
- The appliance requires suitable ventilation in
order to work properly. Leave a space of 30 cm
between walls or other obstacles and 60 cm
- Do not cover or obstruct any of the openings of
the appliance.
- The plug must be easily accessible so it can be
disconnected in an emergency.
appliance it should be situated in a place where
the atmospheric temperature is between 12 and
32ºC.
appliance and so as to be able to install the
appliance on a cold wall (an exterior wall) and
below a window. But never obstructing or cove-
ring a ventilation area.
- The appliance should work well with its wall
support attached.
- The appliance has a wall bracket (D) on which it
can be supported.
- Ensure that the appliance is properly and safely
avoid damaging the appliance, on recommend
manufacturer.
ASSEMBLING THE WALL BRACKET:
- The appliance has a wall bracket (D) on which it
can be supported.
- Taking into account the separation distances
mentioned above, place the wall support in the
required position and mark the drilling points on
the wall. (Fig.1).
- Drill into the wall where marked and insert the
rawlplugs. (Fig.1).
- Place the wall support (D) by matching the holes
should be able to support twice the weight of the
appliance.
- Screw the L-shape (E) onto the appliance using
the screws (H)
- Fit the appliance into the wall bracket (D) and
screw L-shape to the wall.
ASSEMBLING THE STONES:
stone.
tions (Fig.1).
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products packaging has been
removed.
- To eliminate the smell given off by the appliance
to have it on at full power for 2 hours in a well-
ventilated room.
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off switch
(B).
- Turn the appliance on, by using the on/off button
-