Outdoor Leisure TD101A Instrucciones De Ensamble página 2

Estimated assembly time: 55 minutes
Tools required:
• #2 Phillips screwdriver
• 5 mm and 10 mm Open end wrench
Hardware packet provided with heater may contain more parts than
needed for heater assembly.
Hardware packet contains the following items shown on pages 8
through 10 of your owner's manual:
Electronic Ignitor (1), Ignitor Wire (1), Ground Wire (1), Knob (1),
Propane Tank Retention Chain (1), Retention Hook (2), and AA
Battery (1).
1. Locate table heater base and 3 lower table support pillars with
holes on one side only. Making sure holes in pillars are oriented
as shown, slide support pillars into base and attach with screws
(A) and washers (B) through bottom 2 holes as shown.
2
ASSEmBLy
Parts are referenced by designated letter throughout assembly
instructions. Hardware packet contains the following (quantity used
in parenthesis):
Description
A 1" Screw (6)
B 5 mm Washer (6)
C 3/8" Screw (53)
D 3/8" Machine Screw (9)
E 10 mm Hex Nut (6)
F 7/10" Self Tapping Screw (9) 121584-01
2. Position lower table panel and table control panel onto base
assembly as shown. Make certain lower table panel is on side
of base with wheels. Using bottom 3 sets of holes only, attach
panels to support pillars with 12 screws (C).
3. Top sets of screws (C) will insert through panels, through sup-
port pillars, then into pillar support connectors (6 screws). Make
sure pillar support connectors are oriented as shown. The side
of connectors with one hole should be facing outside heater and
hole should be at the top. For support connectors closest to front
opening, second screw will only install through panels and support
connectors. Second screw will secure connector. Attach ignitor
ground wire with 1 screw (ignitor installed in step 4).
www.desatech.com
Part Number
119619-04
A B
119600-02
119620-02
D E
119742-01
119743-01
121451-01A
C
F