Descargar Imprimir esta página

Slime 42013 Guia De Inicio Rapido página 3

Inflador multi-usos inalámbrico

Publicidad

Idiomas disponibles

Idiomas disponibles

HOW TO INFLATE TIRES:
1. Attach air hose to tire by fully screwing the
connector onto the tire valve.
2. Plug power cord into power accessory outlet or
leave unplugged to run from battery.
NOTE: The unit will not run unless the gauge is
turned on by pressing the "set" button.
3. To set the auto shut-off system, press either arrow
button under the display for 3 seconds until the
target pressure blinks.
4. Use the up and down arrow buttons to reach your
target pressure. The inflator will store this pressure
automatically after a few seconds.
5. To inflate, press the button with the tire symbol.
Once your target pressure is reached, the inflator
will shut off. The inflator can be manually shut off
by pressing the tire symbol button again.
6. Unplug power cord (if necessary) and disconnect
the air hose.
NOTE: Correct tire pressure can be found in vehicle's
owner manual or driver's side door jamb.
TO TOGGLE PRESSURE UNITS (PSI/kPa/BAR):
Press the "Set" button at the base of the gauge.
HOLD FOR 3 SECONDS
TARGET PRESSURE
HOW TO USE RAFT PUMP:
The raft air pump is used for inflatables only (more
specifically, high volume/low pressure applications)
and cannot be used for tires and sports balls which
require higher pressure.
1. Attach raft hose to desired inflation adapter, and
make sure connection is tight.
2. Connect hose to the inlet or outlet on the front of
the inflator. The "+" side is used for inflation
and "–" for deflation.
3. Press button with the raft symbol to activate the
raft pump. Once desired pressure is reached, turn
power off and remove all connections.
CAUTION:
1. While operating, never block the inflator input or output.
2. Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure
markings. Be careful not to inflate items beyond their capacity.
3. Never operate the inflator with a beverage in the cup holder.
BATTERY:
· Your unit has been initially charged. However, it is
always good to top it off prior to use for full
performance.
· Note: It takes 16 hours to fully charge your battery
from the wall (AC outlet).
· Note: It takes 6 hours to fully charge from your car
power outlet (DC outlet).
· The unit should be charged every 4 months to keep
the battery at peak performance.
BATTERY LEVEL INDICATOR

Publicidad

loading