Wiseup WIFI23 Manual Del Usuario página 2

(Android) (IOS)
3.2. P2P or LAN Mode Setup
3.2.1. Power on the camera by plugging it into an outlet power socket.
[Note]:
1). The indicator light will illuminate blue for 5 seconds and go out. 30 seconds later, it will blink red and blue slowly,
indicating the camera has entered into the P2P (LAN) mode.
2). Unplug the camera to power it off.
3.2.2. Go to the WIFI or WLAN Settings page on your smartphone or tablet PC, connect your device to
the camera's WIFI signal. The camera's WIFI network SSID starts with CM******** and it will appear on
your WIFI or WLAN Settings page as below: