Blade Assembly; Testing Your Fan - Litex WOD52ABZ5 Manual Del Usuario

9. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in one of the hardware packs. Hold blade arm up
to blade and align holes. (Important: Be sure to
install blades with ridged side facing UP and flat
side facing the FLOOR.) Insert 3 blade attachment
screws (along with washers) with fingers first and
then tighten screws securely with Phillips
screwdriver. Repeat procedure for remaining
blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock
washers to secure blade arms). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat this
procedure with remaining blade arms. Securely
tighten all screws.
Note: Tighten blade arm screws twice a year.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with the pull chain. Start at the OFF
position (no blade movement). First pull will set
the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW. Fourth
pull will again set the fan to OFF setting. If fan
does not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season.
Important: Do NOT remove weatherproof cover
from reverse switch.
Pull chain extension supplied or a custom pull
chain extension (sold separately) can be attached
to pull chain.
plastic
motor lock
lock washers
reverse switch
weatherproof cover
on reverse switch
page 7
motor housing
blade attachment
screws and washers
blade arm
blade arm screws
pull chain
extension
blade