Item Measurement
4 ft. models: 132.8 cm (4 ft.
5
4
/
in.)
16
6 ft. models: 193.8 cm (6 ft.
5
4
/
in.)
16
7
40.3 cm (15
/
in.)
8
1
28.6 cm (11
/
in.)
4
5
36.4 cm (14
/
in.)
16
Physical Specifications
Specification
Measurement
Minimum safe operating
GMR
Fantom
™
™
distance*
2
• 100 W/m
: 1.75 m (5.7 ft.)
2
• 50 W/m
: 2.45 m (8 ft.)
2
• 10 W/m
: 5.40 m (17.7 ft.)
GMR Fantom 56
2
• 100 W/m
: 2.15 m (7.1 ft.)
2
• 50 W/m
: 3.05 m (10 ft.)
2
• 10 W/m
: 6.80 m (22.3 ft.)
GMR Fantom 124
2
• 100 W/m
: 2.65 m (8.7 ft.)
2
• 50 W/m
: 3.75 m (12.3 ft.)
2
• 10 W/m
: 8.40 m (27.6 ft.)
GMR Fantom 126
2
• 100 W/m
: 3.35 m (11 ft.)
2
• 50 W/m
: 4.75 m (15.6 ft.)
2
• 10 W/m
: 10.55 m (34.6 ft.)
Compass-safe distance 300 mm (11.8 in.)
Pedestal weight
15.8 kg (34.8 lb.)
Antenna weight
4 ft. antenna: 5.2 kg (11.4 lb.)
6 ft. antenna: 7.3 kg (16.0 lb.)
Power cable length
15 m (49 ft. 3 in.)
Network cable length
15 m (49 ft. 3 in.)
Antenna rotation speed 24 rpm and 48 rpm
NOTE: The antenna can rotate at 48 rpm only when in single
range mode, with MotionScope
settings of 12 nm or lower.
Maximum wind load
80 kn
Temperature range
From -15 to 55ºC (from 5 to 131ºF)
Humidity
95% at 35°C (95°F)
Water resistance
IEC 60529 IPX6 (protected against heavy seas)
Bearing accuracy
0.25 degrees
*IMPORTANT: The specified 100 W/m
maintained between the antenna and the occupational user and the specified
2
10 W/m
must be maintained between the antenna and the general public.
Under such configuration, the radio frequency radiation exposure limits set
forth for a population/uncontrolled environment are satisfied.
Electrical Specifications
Specification
Measurement
Input voltage
From 10 to 32 Vdc
Fuse
Radar power cable: 15 A, blade-type
Voltage converter cable (if applicable): 30 A, blade-type
Input power
GMR Fantom 54 and 56
• Typical: 65 W
• Maximum: 170 W
GMR Fantom 124 and 126
• Typical: 80 W
• Maximum: 185 W
6
Description
Antenna length
Base of the pedestal to the top of the
antenna
Width of the pedestal at the base
Width of the pedestal in the center
54
™
disabled, and for range
2
minimum distance must to be
Antenna Specifications
Specification
Measurement
Type
End-fed slotted waveguide
Horizontal beam width
4 ft. antenna: 1.8 degrees
6 ft. antenna: 1.25 degrees
Horizontal side lobes
-23 dB within ±10 degrees of main
-30 dB outside ±10 degrees of main
Vertical beam width
22 degrees
Polarization
Horizontal
Open-Source Software License
To view the open-source software license(s) used in this product, go to
developer.garmin.com/open-source/linux/.
Installation Troubleshooting
Symptom
Possible Causes
The radar does not
• The power cable may not be connected correctly to the
turn on. The status
device or to the battery. Check all connections.
LED is not on.
• The inline fuse may have blown. Check the fuse and replace
it if necessary.
• The wire gauge used to extend the power cable may be too
small for the length of the extension. Check the table
provided in the Power Cable Extensions section of these
instructions to make sure the correct wire gauge is used
(Power Cable Extensions, page 4).
The radar is not
• The radar may not be powering on. Check the status LED.
available on the
• The device software may not be up-to-date. Update the
Garmin device or on
software on the device or on the Garmin Marine Network.
devices connected
• The network cable may not be connected correctly to the
to the Garmin
device or to the Garmin Marine Network. Check all
Marine Network.
connections.
• If a field-installable network connector was used, it may have
been installed improperly. Check the connector.
The status LED is located on the product label, and can help troubleshoot
installation problems.
Status LED Color and
Radar Status
Activity
Solid red
The radar is getting ready for use. The LED should be solid
red briefly and change to flashing green.
Flashing green
The radar is operating properly.
Flashing orange
The radar software is being updated.
Flashing red
The radar has encountered an error. Contact Garmin product
support for assistance.
Contacting Garmin Support
• Go to support.garmin.com for help and information, such as product
manuals, frequently asked questions, videos, and customer support.
• In the USA, call 913-397-8200 or 1-800-800-1020.
• In the UK, call 0808 238 0000.
• In Europe, call +44 (0) 870 850 1241.
GMR Fantom
Instructions d'installation
Informations importantes relatives à la sécurité
AVERTISSEMENT
Consultez le guide Informations importantes sur le produit et la sécurité inclus
dans l'emballage du produit pour prendre connaissance des avertissements et
autres informations importantes sur le produit.
Le radar produit des rayonnements électromagnétiques. Assurez-vous que le
radar est installé conformément aux recommandations de ce guide et que
personne ne se trouve sur la trajectoire du faisceau radar avant la
transmission. Lorsque le radar est installé et utilisé correctement, son usage
est conforme aux dispositions de la norme ANSI/IEEE C95.1-1992 « Niveaux
™
50/120
Instructions d'installation