Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Before use
• Before using the appliance, first clean the tank, top cover and body, etc.
• Place the unit upright on a firm and flat surface.
• Plug the appliance into an earthed socket while the unit is switched off.
How to boil water
1. Fill the tank with cold water. There is a maximum level marked on the inside of the
tank – do not fill above this mark. Make sure the environmental temperature indoors
is at about 10-38 °C and the environmental humidity is less than 90%.
2. Replace the cover.
3. Switch the unit on. Adjust the temperature dial to the desired temperature (e.g.
97 °C).
The heating lamp indicator should now light up and the unit will begin to boil the
water.
After about 35 minutes the water temperature will have reached 97 degrees and
the auto-thermostat switch the large heating element off and the small heating
element on, which automatically keeps the water at the correct temperature.
4. When about three cups of water are remaining in the tank, turn the unit off and
unplug it from the electric outlet.
Overheating / boil dry protection
The integrated overheating/boil dry protection will cut the power supply in case the
appliance gets overheated. Both pilot lamps extinguish. After this cut-off a reset of the
fuse is necessary. The appliance can only be restarted after it has cooled down and a
reset of the overheating protection had been done.
1. Switch the appliance off by setting the rocker switch to "O" position and pulling the
mains plug.
2. Let the appliance cool down for a short while and empty the pot.
3. To make a reset of the overheating protection, press the pivot at the underside of the
appliance. You have successfully reset the fuse when you heard a clear "click".
4. Now the appliance can be restarted.
EN
11
Publicidad
