JANE Montecarlo R1 Instrucciones página 18

INSTALLING YOUR MONTECARLO R1 IN THE CAR
3 Fastening the MONTECARLO R1 with the ISOfix anchorings in your car
ISOfix anchorings have been developed to ensure secure and easy
fastening of the child restraining systems in the car. Not all cars have
these anchorings, although they are becoming more standard in newer
models. Consult the attached list of cars in which it has been checked
that the seat can be installed correctly. Future updates of this list can be
checked on the JANÉ website (www.jane.es).
Each manufacturer, depending on the configuration of the seats, can
position its anchorings more or less advanced, which makes regulation
of the position of the ISOfix anchorings on car seats necessary.
If you are going to install your MONTECARLO R1 with rigid anchorings,
carefully follow the steps in the section below:
First remove the protection caps. To do this, pull the anchoring button (3a). Keep
these caps in case you use the MONTECARLO R1 without ISOfix in the future.
Remove the anchoring by pressing the red buttons on the sides (3b).
Ensure that both anchorings are open, you should be able to
see the red signal on the anchorings button (3c).
Position your MONTECARLO R1 on the car seat following the advice and
warnings we gave in the GENERAL INSTRUCTIONS.
Before continuing with the installation, inspect the your car seat to locate
the two ISOfix anchorings. Once you have located them, position your
18
C M Y CM MY CY CMY
MONTECARLO R1 so that the rigid anchorings point towards the car's
ISOfix anchorings. Press the rigid anchorings towards the sear until both are
locked, check that you can see the green signal on the two anchorings (3d).
Continue pressing with greater force until the booster touches the
backrest of the car seat (3e). Make sure that it is firmly in place by
pulling on the seat.
When you wish to remove the MONTECARLO R1 seat, pull the buttons at
the same time that you remove the booster. (3f)
4 Securing your child in the MONTECARLO R1
Place the child in the MONTECARLO R1 seat and make sure he sits well back, pass
the belt over him and fasten it (4a). Insert the shoulder belt through the red belt
guide on the headrest (4b). Pass the abdominal belt under both armrests of the
booster cushion, the area where the belt should go is marked in red again (4c).
Lastly, tighten the belt.
To take the child out of the seat, simply unfasten the seat belt and undo the shoulder
clip.
When not in use, DO NOT leave the MONTECARLO R1 seat loose in the car,
fasten it again with the belt or store it in the boot.
When you put your child in the seat again, make sure that none of the straps
is coiled up or out of position.
K