Gardus LintGard Guia De Inicio Rapido página 4

D A T E R E A D I N G
FAQ'S
QU EST I O N
What if monitor reading is "zero" or oil does not
move up "Sight Tube" when dryer is running?
What if oil does not reach "zero" on scale and
the knob is fully adjusted in?
What precautions should I take if I relocate the
monitor?
Limited Warranty
The LintGard is to be used only as a gage to determine back pressure in dryer vent systems caused by lint build-up or other
restrictions. Its only purpose is to provide a visual guide to help determine when the dryer exhaust duct should be cleaned.
The LintGard and all components are warranted for a period of one year from date of purchase. Should any part fail due to
a manufacturing defect, return the defective part to Gardus, Inc. and we will repair or replace it free of charge once the unit is
confirmed to be defective. Please call 203-985-0208 for a return authorization number prior to returning any item. The terms of
this warranty shall not exceed the replacement cost of the LintGard.
Gardus, Inc. does not warranty failure of any part due to operator error. Be sure to read all installation and operating
instructions before use.
Gardus, Inc. and any of its subsidiaries accept no liability for property damage or personal injury due to the operation or
failure of the LintGard and accessories. This is the full extent of the warranty made by Gardus, Inc. All implied warranties are
hereby excluded..
CAUTION: RED GAGE OIL (0.826 SPECIFIC GRAVITY)
> Avoid contact with red gage oil contained within the LintGard monitor.
> If contact with skin occurs, wash with soap and water.
> Mild eye irritant. If contact occurs, flush eyes with water. Get medical attention.
> If swallowed, do "not" induce vomiting. Get medical attention.
> Keep Out of Reach of Children
D A T E
A N SWE R
Remove clear tube from side of monitor. Blow into tube. This should clear any
blockage. Reconnect tube to port by pressing firmly.
After a long period of time, it may be necessary to add oil. Please call 888-985-
0208 to order.
When moving the LintGard to another location, be sure to follow the steps below
before removing unit from wall.
1. Remove Vent Cap on top of monitor by prying up with small screwdriver.
2. Remove clear tube from port on side of unit.
3. Connect a short piece of tubing from port on side of unit to port on top of unit.
This will contain the gage oil and prevent spillage.
888-985-0208 (toll free)
sales@gardus-inc.com • www.gardusinc.com • www.lintgard.com
R E A D I N G
MADE IN CHINA
D A T E R E A D I N G