Ecco EW4030 Instrucciones De Instalación Y Operación

IMPORTANT!
Read all instructions before installing and using. Installer: This manual must be delivered to the
end user. ECCO is not responsible for the misuse of products by un-authorized personnel.
Do not install and/or operate this safety product unless you have read and understand the safety information contained in this manual.
1. Proper installation combined with operator training in the use, care, and maintenance of emergency safety devices are essential to ensure
the safety of you and those you are seeking to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high current arcing,
which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation are vital to the performance of this safety device. Install this product so that output performance of the
system is maximized and the controls are placed within convenient reach of the operator so that s/he can operate the system without los-
ing eye contact with the roadway.
5. Do not install this product or route any wires in the deployment area of an air bag. Equipment mounted or located in an air bag deploy-
ment area may reduce the effectiveness of the air bag or become a projectile that could cause serious personal injury or death. Refer to
the vehicle owner's manual for the air bag deployment area. It is the responsibility of the user/operator to determine a suitable mounting
location ensuring the safety of all passengers inside the vehicle particularly avoiding areas of potential head impact.
6. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the vehicle
operator should ensure the projection of the safety signal is not blocked by vehicle components (i.e., open trunks or compartment doors),
people, vehicles or other obstructions.
7. The use of this or any other safety device does not ensure all drivers can or will observe or react to a warning signal. Never take the
right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an intersection, driving against traffic,
responding at a high rate of speed, or walking on or around traffic lanes.
8. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying all laws regard-
ing warning signal devices. Therefore, the user should check all applicable city, state, and federal laws and regulations. The manufacturer
assumes no liability for any loss resulting from the use of this safety device.
Note:
Black die cast aluminum housing gets very hot to the touch after operating constantly for several hours.
Specifications:
Size:
Weight:
Input Voltage:
Temperature Range:
Peak Current Draw at 12.8 VDC:
Max Power Draw at 12.8VDC:
10.5" L X 4.3" H X 2.3" D
4.12 lbs.
12-24 VDC
-40° to 150°F
-40° to 65°C
3.7A
47.6W
MOUNTING SURFACE
FIGURE 1
Installation and Operation Instructions
EW4030 SCENE LIGHT
Prior to installation:
Carefully remove the unit from its packaging. If damage is found, contact
the transit company or ECCO. Do not use broken or damaged parts.
Prior to mounting, consideration should be given to cable location.
Bracket Mounting:
1. Drill two holes in the mounting surface matching the holes in the
bracket.
2. Insert the hex head bolts through the mounting bracket and loosely
assembly the bracket onto the light as shown. The EZ4030 bracket, for
dual light assembly, is sold separately.
3. Secure the light in place with the supplied hardware. Adjust the light
beam angle as needed before tightening the screws on each side.
MOUNTING
SURFACE
MOUNTING
SURFACE
FIGURE 2
Page 1 of 2