Publicidad
Idiomas disponibles
Idiomas disponibles
1C
9
CONNECTOR WIRES
8
Feed the connector wires through the transformer.
9
Connect the black transformer wire to the black
connector wires with a wire nut.
Connect the red transformer wire to the red connector
10
wires with a wire nut.
10
8
1D
TRANSFORMER
COVER
PHILLIPS SCREW
11
Connect the 120 volt power line wires at the panel.
12
After installing the entire system, operate the system for
five minutes. On the low voltage side, all electrical
connection points should be no more than warm to the
touch. If a connection is hot to the touch, retighten the
connection and check to ensure that the temperature
decreases.
13
Replace the transformer cover and tighten the four
Phillips screws.
3
14
14
14
14
Publicidad
