DJI MATRICE 200 Serie Guia De Inicio Rapido página 8

Mounting the Gimbal and Camera
1 1
Press the Gimbal Align the white and
Detachment button red dots and insert
to remove the cover. the gimbal.
Make sure to press down the gimbal detachment button when rotating the gimbal lock to remove the gimbal and camera. The gimbal lock should be fully rotated when
removing the gimbal for the next installation.
Mounting the Intelligent Flight Batteries
Insert a pair of batteries.
Press once to check the battery level.
Press again and hold until the batteries turn on or off.
Only use battery slot B when only using one battery to supply power.
Make sure to press the Battery Removal button when removing the battery.
Mounting the D-RTK Ground System
For the M200 series, only mount the D-RTK Ground System to
the M210 RTK.
1. Rotate the screws to secure the antenna bracket, and install
the battery.
2. Rotate the clamp to secure the battery, and install the
Datalink Pro antenna.
3. Install the D-RTK Ground System onto an appropriate tripod.
This manual uses the Datalink Pro 900 as an example. Please refer to the
D-RTK and Datalink Pro user guides for more details.
Activating D-RTK and Datalink Pro
For the M200 series, you can only activate D-RTK and Datalink Pro with the M210 RTK. Be sure to activate both with DJI
Assistant 2 before first time use.
Micro USB
Connect the Datalink Pro Air System, Datalink Pro Ground
System, and D-RTK Ground System one by one to the
computer with a Micro USB cable for activation.
Ensure that the D-RTK Ground System is powered on first. DO NOT power on the aircraft before the D-RTK Ground System's Working Status LED is solid green.
Set the Flight Mode Switch to P mode or F mode.
2 3
Rotate the gimbal
lock to the locked
position.
Gimbal Connector II
Zenmuse XT
Zenmuse Z30
A
B
1
3
2
Connect the aircraft to the computer and toggle the
USB Mode Switch to the RTK position for activation.
Gimbal Connector I
Zenmuse X4S/X5S/Z30
Zenmuse X4S/X5S/XT
High
Low
4
5
1/4"or3/8"
7