"Clock" Function; Led Indicator - RIB MINI WIRELESS Manual Del Usuario

8.3 Winter mode
This mode allows you to block all commands gived by the sensors to MINI WIRELESS. It is useful during the winter.
1. Awning must not be in movement. It can be stopped at any position
2. Press and hold the CLOSE "b" button for 5 s.
3. The yellow LED indicates the entry of the winter mode with a blink every 2 s.
4. The awning closes and once it has closed, MINI WIRELESS will ignore all the commands given by the sensors.
To exit the winter mode, it's sufficient to provide an opening command and MINI WIRELESS will return to the automatic mode

8.4 "Clock" function

The clock function cannot be used with push buttons setted in hold-to-run mode (DIP 2 OFF) nor with the light sensor enabled (DIP
5 ON).
This mode allows you to open and close the awning at specific times using a timer (which maintains closed the wired contact "open"
for more than 4 minutes).
The awning will remain open until the contact is closed.
An alarm gived by a sensor will close the awning.
When the alarm ends, the awning will reopen completely, regardless of the position of DIP 1 (automatic reopening after alarm).

8.5 LED indicator

The control board is equipped with 8 LEDs for indicating the status of the sensors, and handling operations
LED1 LED2 LED3 LED4 LED5 LED6 LED7 LED8
LED1 ON: light beyond the set value
LED2 ON: wind speed beyond the set value
LED3 ON: rain detected
LED 4 ON: snow detected (see 6.3)
LED5 ON: the control board is using the internal memory
LED6 ON: clock function enabled
LED7 ON: awning is closing
LED8 ON: awning is opening
19