Campbell Hausfeld WL5000 Serie Guía De Usuario página 4

Portable Air Compressors
Operation (Cont.)
close cock tightly before operating
compressor. This helps prevent tank
corrosion and keeps oil and moisture
out of air used.
4. Change air filter: Never run
compressor without an air filter nor
with a clogged air filter. Clean air
filter with plain soapy water when
dirty or replace with a new one.
Replace filter if dirty.
bREAk-IN
Do not attach air
chuck or other tool to
open end of hose until start-up has been
completed and unit checks OK.
1. Turn regulator knob fully clockwise.
Close
Air Flow
Figure 4
2. Turn switch or knob to OFF position,
and plug in power cord.
3. Turn switch or knob to AUTO position
and run unit for 30 minutes to break
in pump parts.
Off position
Auto position
Figure 5
4. Turn regulator knob fully
counterclockwise. Compressor will
build to maximum preset pressure and
shut off.
5. Turn regulator knob clockwise to
cause air to bleed off. Compressor will
restart at present pressure.
6. Turn regulator knob counterclockwise
to shut off air and turn switch to OFF
position.
7. Attach air chuck or other tool to open
end of hose. Turn regulator fully ON.
Apply a soap and water solution
around hose fittings and check for
signs of leaks (bubbles forming). If
there is a leak, tighten connections
and check again. When there are no
leaks, compressor is ready for
operation.
Figure 6
Open
MANIFOLD ASSEMbLy
Locations of parts may vary depending on
Attach
Hose
model. Regulator is attached to tank on
twin tank models.
Pressure
Switch
Safety
Valve
Figure 7
ASME SAFETy VALVE
1. This valve automatically releases air if
air receiver pressure exceeds preset
maximum.
valve!
2. This valve should be checked
occasionally by pulling the ring by
hand. If air leaks after ring has been
released, or valve is stuck and cannot be
actuated by ring, it MUST be replaced.
Figure 8
Regulator
Tank
Pressure
Gauge
Outlet
Pressure Gauge
Do not attempt to
tamper with this
4
REGULATOR kNOb
1. This knob controls air pressure to an air
operated tool, or paint spray gun.
2. Turning knob clockwise increases air
pressure at outlet.
3. Turning counterclockwise will lower air
pressure at outlet.
4. Fully counterclockwise will shut off flow
of air completely.
Close
Figure 9
REGULATED OUTLET GAUGE
1. This gauge shows at-a-glance, air
pressure at outlet. Air pressure is
measured in pounds per square inch
(PSI).
2. Be sure this gauge reads ZERO before
changing air tools or disconnecting hose
from outlet.
Figure 10
TANk PRESSURE GAUGE
Gauge shows pressure in air receiver
indicating compressor is building pressure
properly.
Maintenance
Release all
pressure and
disconnect power before making any repair.
1. Check compressor for any visible
problems, especially check air filter to
be sure it is clean.
2. Pull ring on safety valve and allow it to
snap back to normal position.
Figure 11
Open
Attach
Hose