en
6.
3 Cleaning
In order that you benefit fully from your equipment, it is important that the machine and accessories
are kept in a clean condition. Ensure that the medication chamber is taken apart and washed in warm
soapy water. Rinse and allow to dry after each use. The jet holes should be blown clear by attaching
the chamber to the air outlet from the compressor and running the machine for a couple of minutes.
We advise that the tube is disconnected from both the outlet filter and the chamber after each use to
prolong the life of the connector.
6.
4 Changing the Attachments
}
It is recommended that the following disposable items should be changed as follows:
Nebuliser chamber
Inlet filter
Driveline
Face Mask
}
Mouthpiece
Outlet filter
Only nebuliser chambers supplied or approved by CCI should be used.
6.
5 Replace filters for the Econoneb/Turboneb 2
Inlet filter:
Using the filter spanner, unscrew your used,
direction and discard.
Replace with a new filter, ensuring you have the
white
Screw the
inlet filter, into the left-hand hole on the front panel, in a clockwise
direction, tightening with the filter spanner.
Outlet filter:
Using the filter spanner, unscrew your used,
direction and discard.
Replace with a new filter, ensuring you have the
blue
Screw the
outlet filter, into the right-hand hole on the front panel, in a
clockwise direction, tightening with the filter spanner.
6
change every 3 months
change every 12 months
white
white
blue
blue
, inlet filter in an anti-clockwise
inlet filter.
, outlet filter in an anti-clockwise
outlet filter.