Installation - Klarstein APPETITO 4 ZONES Manual Del Usuario

INSTALLATION

Installing the cooker hob
• The area where the hob is installed should be dry and adequately ventilated.
During installation, make sure that all controls are easily accessible.
• This is a Y-type design built-in ceramic, which means that its back wall and one side
wall can be placed next to a high piece of furniture or a wall. Coating or veneer
used on fitted furniture must be applied with a heat-resistant adhesive (100 °C). This
prevents surface deformation or detachment the coating.
• Hoods should be installed according to the manufacturer's instructions.
Assembly of the cooker hob
• Cut an opening for the hob out of the worktop, taking into account the dimensions
shown in the figure below.
• Check seal for perfect fit and overall cover. Lower the electric hob into place and
align correctly.
• Using a standard screwdriver, tighten the tension clamps evenly starting at the
centre and moving diagonal, until the built-in rim is tight on the worktop.
Installation dimensions
EN
17