Operation Instructions; Using Flat Wrappers - Royal Sovereign Sort 'N Save MS-1 El Manual Del Propietario

oPeration inStruCtion
1. Place the machine on a flat sturdy surface.
2. Screw the handle onto the right side of the machine.
3. Open the front cover and pull the coin tubes out. Insert pre-formed coin wrappers into the corresponding coin tubes
(We recommend FSW-216N Royal Sovereign coin wrappers).
4. Place coins into the collection opening.
5. Place one hand on the top left corner of the machine and place the other hand on the Handle.
6. Turn the handle CLOCKWISE to sort coins. If a coin jams gently turn the handle COUNTERCLOCKWISE but do not exceed a
180° turn.
note: turning the handle Counterclockwise more than 180° may cause coins jams or damage the machine.
7. Coins will sort into the corresponding coin tubes.
8. When a tube is full, pull out the tube tray where the full tube is located.
9. To remove filled wrappers, pull up on the exposed edge of the plastic tube and remove. Then push the coin wrapper up
from the bottom of the tube and fold edges of wrapper.
10. Place a new wrapper into the coin tube and return the tube back in place.

uSinG flat WraPPerS

1. Allow coins to fall directly into plastic tubes. Do not place flat wrappers into plastic tubes while operating.
2. Remove full coin tubes after sorting.
3. Hold a flat wrapper open by placing your index finger slightly inside the end of the wrapper. Slide the flat wrapper over the
top few coins in the tube.
4. While gently pushing the wrapper toward the bottom of the coin tube, tilt the coin tube so that the coins slide into the
wrapper. When the wrapper touches the bottom of the coin tube, hold the tube upright, fold the top of the wrapper.
5. Turn the coin tube upside down and remove the coin-filled wrapper. Fold over the other end of the wrapper.
note: Because pennies and dimes are very close in size and thickness, they may sometimes sort into opposite tubes.
DO NOT USE DAMAGED, BENT, EXCESSIVELY DIRTY OR FOREIGN COINS. THIS WILL CAUSE JAMMING AND MIS-SORTING.
4