Care and Cleaning
□
To clean, wipe down with a damp cloth and towel dry.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will be
voided.
Troubleshooting
NOTE: Refer to the service parts section in this manual for a
detailed drawing showing the location of the parts listed below.
Problem
There are leaks from the
handle.
The pull-down spray leaks or
has a reduced water flow.
There are leaks from the hose
underneath the deck.
The hose does not retract.
The water pressure is low.
There is no hot or cold water.
Possible Cause
□
The bonnet nut is loose.
□
The O-ring on the cartridge is
dirty or damaged.
□
The pull-down spray is dirty or
mis-fitted.
□
The cartridge may be clogged.
□
The connection between the
pull-down spray and pull-down
spray hose may be loose.
□
The weight is not installed in the
correct position.
□
The pull-down spray hose is
obstructed.
□
The quick connector may be
clogged with debris.
□
The hot or cold water supply
lines may be kinked or twisted.
Solution
□
Tighten the bonnet nut.
□
Clean or replace the O-ring.
□
Remove the pull-down spray and
check for debris.
□
Remove the cartridge and check for
debris.
□
Ensure the pull-down spray is
properly installed.
□
Tighten the connection between the
pulldown spray and pull-down spray
hose.
□
Reinstall or readjust the weight.
□
Check under the sink to ensure
the pull-down spray hose is not
obstructed.
□
Turn off the water supply and
disconnect the quick connector from
the outlet hose.
□
Disconnect the quick connector from
the pull-down spray hose and flush
under running water.
□
Reattach the quick connector to the
outlet hose.
□
Test water flow. If water pressure
is still low then replace the quick
connector.
□
Ensure hot and cold water supply
lines are not kinked or twisted.
Reinstall the supply line if necessary.
8