Westfalia 316193600001 Manual De Montaje página 2

SIARR
04 - 114
PREPARATION
* Remove the bumper.
* Loosen the lower fastening screw
on the exhaust.
ASSEMBLY
* Put the 2 right and left screws on the outside
of the side members and attach them, without
tightening, using fastening set X.
* Fasten bracket B on the right-hand side
of the rear skirt using fastening set Y.
* Fasten the cross sill of coupling A to the rear
skirt using fastening sets Y and W.
* Make a cut-out in the centre of the bumper (Fig.1).
FINISHING
* Tighten the exhaust screw again.
* Tighten all the fastenings to the
couplings shown below.
* Replace the back bumper.
FASTENING KIT
4 HM10x25 screws
4 CS10 washers
X
4 HM10 nuts
4 10-22 plain washers
4 HM10x25 screws
Y
4 CS10 washers
4 HM10 nuts
M16 AC8.8 19,5daNm M12
M16 AC10.9 27,5daNm M10
M12 AC8.8 8,1daNm M10
ASSEMBLY INSTRUCTIONS
4 HM16x45 screws
Z
4 DEC16 washers
4 HM16 nuts
2 HM10x40 screws
W
2 CS10 washers
TORQUES :
AC10.9 11,4daNm M8 AC8.8
AC8.8 4,7daNm M8 AC10.9
AC10.9 6,7daNm
Type Type
Approval No.
Towbar for
Renault Twingo e11*94/20*00*1449
Ph.II
NOTA : Schéma électrique à l'intérieur de nos faisceaux universels ou personnalisés.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
FICHIER : BUREAU\NOTICEDEMONTAGE\SIARR\NDM04\NDM04114-F - FOLIO NDMANG
316193600001
Max. Total Max. Total
Authori. Weight Towable Weight
1 220 kg 600 kg
Max. Verti- Value
cal load D
45 kg 3,95 kN