Troubleshooting - Temper KOBAN KDP Manual Del Usuario

Button
Short impulse mode for load I (CH1)
In this mode Load I(CH1) will on 1sec and off 9sec when
detector detects movement. Detector acts depending on
movement and the pre-set Lux value under short impulse
mode.
To set delay off TIME2 (HVAC)
By pressing corresponding button, the desired swithing off
delay time of load II (CH2) for HVAC can be exactly set, it is
confirmed by flashing of detector
If detector has only one load, TIME2 is invalid.
Short impulse mode for load II (CH2)
In this mode LoadⅡ(CH2) will on 5sec and off 5sec when
detector detects movement. Detector acts depending on
movement regardless of Lux value setting under short impulse
mode.

Troubleshooting

Problem Possible cause
Detector fails 1. Exceed the
to receive transmission range.
signal
2. Low battery power.
3. Detector works
abnormally.
No signal 1. Low battery power.
2. Press two or more
buttons once.
Fail to transmit In locked mode.
signal
www.grupotemper.com
Remote control
Function
s LED for 2sec.
'
Suggested solution
1. Operate within transmission range,
and ensure KDP aims directly to the
detector.
2. Replace a new battery.
3. Check the trouble of detector, then
refer the TROUBLE SHOOTING of
detector manual for reparing.
1. Replace battery.
2. Press one button once.
Unlock the controller.
Instructions manual |
KDP
17