Publicidad
Idiomas disponibles
Idiomas disponibles
Install the GearLoft™ Shelf to the Wall
IMPORTANT:
Be sure the Gladiator
®
GearWall
are installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
®
®
If Gladiator
GearTrack
GearLoft™ shelf, they must be installed 6" (15.24 cm) apart.
6" (15.24 cm)
1. Determine shelf mounting location on GearWall
GearTrack
®
channels.
2. Insert the brackets into the GearTrack
rim extension fits behind the upper channel groove.
3. Slide the brackets in the channel so they are spaced 43"
(109.22 cm) apart, as shown.
NOTE: Install brackets into the upper channel for installations
with the braces above the shelf, or into the lower channel for
installations with the braces below the shelf.
43"(109.22cm)
4. Engage the bracket that is welded to the back of the shelf into
the wall slot by lifting up, pushing toward the wall and lowering
the bracket rim into the slot as shown.
®
panels or GearTrack
channels will be used to mount the
®
panels or
®
channel so that bracket
5. Make sure the screws on the brackets go through the holes in the
braces. Fasten the braces to the brackets using the wing
nuts (F11).
NOTE: You may need to adjust the brackets to the right or left if
the screws do not align with the holes.
®
channels
6. Inspect the shelf from the side to ensure the bracket rims are fully
engaged in the slots as shown.
7. Completely tighten the wing nuts (F11).
For warranty information:
In U.S.A. call 1-866-342-4089 or visit our website at
www.GladiatorGW.com
In Canada call 1-800-807-6777 or visit our website at
www.gladiatorgarageworks.ca
A
A. Mounting brackets fully engaged in slots
Warranty
Publicidad
