Publicidad
Idiomas disponibles
Idiomas disponibles
Using MS Greenline Maggot death
ATTENTION! Always flush the MS Greenline thoroughly before switching from foaming product or disinfectant to MS
Maggot Death Plus. Make sure that only pure clean water is coming out when you start to mix the MS Maggot Death.
Any contact with disinfectant or foaming product residue can lead to a negative effect on MS Maggot Death's action.
1.
Add 7 kg of MS Maggot death Plus hrough
the large hole (Figure 8) with the green lid.
2.
Then, close the lid and connect the pressure
washer to the lance that is mounted in the
mixture container (Figure 9).
3.
Now add 28 litres of water (i.e. fill it up to
35 litres). Use a rotating action so that the
MS Maggot death Plus mixes well.
4.
In that way you fill and mix in one go. The container now contains 35 litres of solution, which is sufficient for
2
treating 280 m
of pit surface. In normal circumstances, that should take you half an hour to apply.
Dosage table
2)
Surface area (m
:
Maggot death (kg)
40
80
120
160
200
240
280
320
Points for attention
Five litres of the solution is sufficient to treat 40 m
factor. Check it during application. For example, if you have used five litres and you can see that you have treated
2
30 m
of pit surface area, you should move along a little faster.
After preparation, use the ready-mixed solution straight away.
MS Maggot death Plus characteristics :
Active ingredient: cyromazine
Long-term action (up to 12 weeks)
Very soluble in water
Non-toxic
No known resistance worldwide
Use biocides safely. Read the label and product information before use.
Figure 8
Added water (Litres)
1
4
2
8
3
12
4
16
5
20
6
24
7
28
8
32
2
of pit surface area. Your working rate should be attuned to that
Figure 9
Total amount of
solution (L)
5
10
15
20
25
30
35
40
Pagina 8 van 20
Publicidad
