ATORN 33172111 Modo De Empleo página 13

9. Personalising the instrument
E
Access to the functions of your instrument can be personalised using the free S_Dial WORK Demo or Sylconnect
software, which is available on the www.sylvac.ch website (requires you to connect your instrument via a Proximity or
Power RS / USB cable).
This program enables you to:
- De-activate or active the required functions
- Modify access to the advanced functions (direct access)
10. Connecting the instrument
The instrument can be connected to a peripheral via a Proximity (RS or USB), or Power-RS (Power-USB) cable
See page 2 for connecting the Power cable.
Measured values can be transmitted and the instrument driven using predefi ned retro-commands (See Chap. 11 for a list
of the main retro-commands)
Note: In Tolerance mode, the tolerance limit lights remain lit only for a few seconds while the measurement stabilises. On
the other hand, they will remain lit continuously if the instrument is connected to, and powered by, the Power RS (USB)
cable.
13