Genie 37303r Guía De Instalación Rápida

Screw Drive Rail Extension Kit
(For 8 foot tall garage doors)
WARNING
!
Carefully read all instructions and warnings
contained in the Assembly/Installation poster
and/or Owners Manual prior to assembly of this
kit. Safety glasses are required for this assembly.
CAUTION
!
Edges of rail and connector sections can be sharp.
Avoid contact with edges.
A
1.Slide collar over
FIG. 1
long hook
FIG. 2
37387503963, 04/2018
All manuals and user guides at all-guides.com
NOTICE: These instructions supersede installation poster steps 3 & 4 (1c & 1d)
Parts Included: Screw Extension (XS), Additional Rail Connector (K), Rail Extension (X), 2-ea. Clips & Collars.
ASSEMBLE THIS KIT ON A FLAT CLEAN WORK SURFACE.
1. Assemble screw rail per installation poster steps 1 through 2 (1a/1b).
2. Pull screw drive sections out of rail sections B & C to allow assembly of extension screw. FIG. 1.
3. Install screw extension (XS) between sections B & C with clips and collars included with this kit.
FIG. 1.
4. Install rail connector K to rail section B until it locks. Care should be taken NOT to bend screw
connections. FIG. 2.
5. Install rail section C into rail connector K until it locks. Care should be taken NOT to bend screw
connections. FIG. 2.
• Screw drive section will now protrude beyond original rail section C. FIG. 3.
6. Install rail connector XK onto rail section C until it locks. FIG. 3.
7. Install rail extension X into rail connector XK until it locks.
8. Continue assembling screw rail assembly per installation poster step 5 (1e).
• Remember to complete step 6 (1f) for screw sections A & B.
K B
2.Mate hooks
B
FIG. 3
(Alpha numeric digits in parenthesis (1a) indicate steps on older posters)
XS
4.Snap clip
behind collar
3.Slide collar
over joint
Completed Connection
K
XK
C
C
X