Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

PROBLEM
Motor starts slowly or fails to come
to full speed
Tool does not drive screw into
material
Tool does not complete drive
Screws do not advance
Screws fall out during application
Bit does not install correctly
Bit slides or jumps off screw
Screw is driven at an angle
Screw jams
Slide mechanism sticks or "returns"
slowly
Motor overheats
Pushing force becomes difficult
CAUSE
Starting switch not operating
Battery pack is not charged
Bit is worn
Overloaded motor
Depth of drive improperly set
Bit is clogged or worn
Screw length not set correctly
Screw length not set correctly
Bit track is damaged or worn
Bit not properly seated into bit
housing
Tool is pushed forward during drive
Tool is out of alignment
Bit track is damaged or worn
Screw length not set properly
Nosepiece screw loosened
Bit track is damaged or worn
Bit is damaged or worn
Nosepiece is bent or damaged
Build up of debris in mechanism
Weak return spring
Overloaded motor
Slide body assembly is worn
11 - English
SOLUTION
Have switch replaced
Charge the battery pack according
to the instructions included with your
charger
Replace the bit
Check applications section for proper
uses
Adjust depth of drive
Clean or replace bit
Adjust according to "Setting Screw
Length" section
Adjust according to "Setting Screw
Length" section
Replace slide body assembly
Refer to "Install Bits" section
Hold tool firmly while working
Return to authorized service center
Replace slide body assembly
Adjust according to "Setting Screw
Length" section
Tighten nosepiece screw
Replace slide body assembly
Replace bit
Replace nosepiece
Clean return mechanism
Replace spring
Check applications section for proper
uses
Replace slide body assembly

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido