Original Instructions - Metabo KE 3000 Manual Original

Ocultar thumbs Ver también para KE 3000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 12
en
ENGLISH

Original instructions

1. Declaration of Conformity
We, being solely responsible, hereby declare that
these glue guns, identified by type and serial
number (KE 3000,18121..), meet all relevant
requirements of directives *1) and standards *2).
Technical documents for *3) - see below:
*1) 2014/30/EU, 2014/35/EU, 2011/65/EU
*2) EN 60335-1, EN 60335-2-45, EN 50581:2012
*3) Vice President Product Engineering & Quality
Responsible person for Documentation
Metabowerke GmbH, 72622 Nuertingen, Germany
2. Special Safety Instructions
Carefully read through
the operating
instruction in their
entirety. Keep all of the documents
supplied and pass them on to the
new owner if you part with the unit.
The hot-melt glue can reach a
temperature of up to 200°C!
Caution, risk of burns!
Use only genuine Metabo
accessories.
Nozzle set (consisting of threaded
bush, flat nozzle and crevice
nozzle). Only replace when device
has operating temperature.
Caution risk of burns! Use
protective gloves or similar.
Disconnect the mains plug
before starting any
maintenance work!
Do not store within the reach of
children.
Perfect functioning is guaranteed
only if original Metabo and/or
Pattex hot-melt glue sticks are
used.
This device is not designed for use
by persons (including children)
4
2017-06-01
Bernd Fleischmann
with physical, sensory or mental
disabilities, or with insufficient
experience and/or knowledge,
unless they are supervised by a
person responsible for their safety,
or have received instructions on
how to use the device by this
person.
Never allow children to use the
machine.
Children should be supervised to
ensure that they do not play with
the tool.
3. Use
Attach wire support and insert hot-melt glue sticks.
Place glue gun on wire support (if needed use a
cardboard or wood support). Plug in.
Heat up the glue gun for about 7 minutes.
Actuate the feed and apply the glue.
Firmly press together the materials to be glued and
correct if needed. The bonding surface is able to be
put under load after a short while.
4. Tips and Tricks
For particularly good work results:
The parts to be bonded (sealing or grouting) parts
must be free from grease, must be dry and
absolutely clean.
Apply the hot-melt glue in dots or strips. Do not
spread.
The parts to be bonded should have room
temperature. Heat cold tiles, marble etc. prior to the
application (e.g. with a hot air gun).
Materials that are difficult to bond (rubber, metal,
particular plastics) should be roughened prior to
applying the hot-melt glue (e.g. with fine
sandpaper).
Rigid foam (e.g. polystyrene) can also be
processed without any problems. Apply the hot glue
to the underground and not onto the polystyrene.
When bonding on smooth and/or somewhat colder
surfaces (e.g. metal) first apply the hot-melt glue to
the smooth and/or somewhat colder surface.
In case of larger surfaces always apply the glue in
dots (larger glue dots). For bonding larger surfaces,
use only hot-melt glue with an open time of more
than 20 seconds.
When bonding textiles or similar materials, apply
the hot-melt glue in wavy lines.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

618121000

Tabla de contenido