Pentair Pentek Solar Drive Specifications - Pentair PENTEK PSD15 Manual De Instalación Y Funcionamiento

PENTAIR PENTEK
Input Specification:
- Minimum Operating Voltage:
- Maximum Solar Open Circuit Voltage:
- Maximum Solar PV Current in Series:
- Earth-ground connected to chassis
Output Specification:
- Maximum Output Current:
- Maximum Power Sustained:
Protections:
- Short-circuit, ground-fault, over-temperature, overload, over-voltage, over-current,
and solar input reverse polarity protection
- Automatic dry well protection and pump locked rotor protection
Integral solid state short circuit protection does not provide branch circuit protection.
Branch circuit protection must be provided in accordance with the National Electrical
Code and any additional local codes.
ELECTRICAL
Solar PV open circuit voltage: 400V
Max PV panel current in series: 9A
Max Three phase AC motor current: 7A
Carefully check the motor load specifications and solar PV array maximum power
point voltage to set up the system properly using this manual!
Environmental – Compliance with IEC 60068
IEC 60068-2-2 – Cold
IEC 60068-2-14 – Change of Temperature
P1061 (06/06/19)
SOLAR DRIVE SPECIFICATIONS
*
100 Vdc (for 115 Vac)
150 Vdc (for 230 Vac)
400 Vdc
9 Amps
7 Arms (3-phase motors)
2000W
Degree of protection: TYPE 4
Enclosure material: Aluminum
Operating temperature: -40˚C to 50˚C
AC Source Terminals: AWG #10-16
Solar Terminals: AWG #10-16
Motor terminal: AWG #8-16
Float Sensor terminals: AWG #14-20
WARNING:
IEC 60068-2-2 – Dry Heat
IEC 60068-2-30 – Damp Heat
MECHANICAL
Dimensions: 10"x5.5"x4"
5