Lagrange Hemisphere Manual Del Usuario página 48

Boil the water with prolongation of boiling then lower to
*
a predefined temperature and maintain this temperature:
Press the temperature selection button to display the possible
temperatures and choose between
the "PURE" button. The "PURE" button, the temperature selection
button and the water level indicator go on.
The temperature chosen will blink on the screen and the water will
start to warm up.
The display on the screen will then go to the instantaneous temperature
of the water.
The temperature selected can be seen by the point facing
the temperature.
The water will go up to °C and the boiling will be maintained
100
for minutes.
3
At the end of the prolonged boiling cycle, the kettle will beep
and the "PURE" button will go off.
The water temperature will then progressively go down, which can
take time, be patient!
Once the selected temperature has been reached, the kettle will
beep and keep the water at this temperature automatically for
minutes and then go off.
30
The temperature selection button and the water level indicator
will go off.
The water temperature will then be displayed on the screen.
The boiling prolongation mode can be cancelled by simply pressing
the "PURE" button.
The temperature selection mode can be cancelled by simply pressing
the temperature selection button.
N.B.: A sound is heard each time you press a button of the kettle.
, , or °C. Then press
50 60 70 85
times
5
Warning: There can be a difference in temperature of
or less between the water inside the kettle and the display on
the screen.
Advice: you can reduce the length of your cord in the storage support,
which is under the base.
Anti-dry boiling system
If the "MIN" water level is not respected, the kettle will beep and will
not start: this is the anti-dry boiling system.
UPKEEP
For cleaning the unit, you should take care to always unplug the
*
unit and let it cool down before washing it. Do not put the base,
the cord or the plug into water. Do not allow water to enter the
base of the kettle.
Clean the kettle and the base with a moist cloth. If the kettle is very
*
dirty, add a small amount of soap.
Do not use scouring pads, steel wool or any form of powerful solvents
*
or abrasive cleaning products to clean the unit, because they can
damage the exterior surfaces of the unit.
Remove the scale filter by pulling it up and clean it using a brush.
*
Put it back in place once it has been cleaned.
IMPORTANT! Let the unit dry completely after cleaning before using
*
it again. The unit should not be used if the base or the underside
of the kettle is wet.
Make sure that the unit is dry and clean before storing it.
*
48 48
°C more
5