Addendum
A50 HANDSET REGISTRATION
1
Begin with handsets fully charged for 24 hours. Remove
all handsets from the charging bases, bringing all of them to the
main base and setting them on the counter right next to the
main charging base. (The handsets cannot be registered while
they are in the charging base).
process.
2
Put your one finger on the PAGE button on the main
base.
Very important - - You must hold this button down
during the whole registration process for all involved handsets
without lifting it off. If the button is released, you must start
over.
3
At the same time - - with your other hand, press and hold
the "CH" button on the 1st handset until you hear 2 quick
confirmation beeps.
4
Immediately move your hand to the next handset – without
lifting the PAGE button, press and hold the "CH" button on the
2nd handset until you hear 2 quick confirmation beeps.
(Repeat for 3
button).
5 Release your hand from the PAGE button now on the main
charging base.
6
Handset 1 should now show "HS-1" on the display.
Handset 2 should now show "HS-2" on the display. (If you have
rd
a 3
Handset, it will now show "HS-3").
7 You should now have a dial tone on all the handsets.
NOTE:
If any handset loses registration, then this process must be
repeated for all handsets in order to bring all handsets back into
registration.
rd
handset if applicable – without lifting the PAGE
Get ready for this 2-handed