Learning Commands; Master Clear - Philips PM725S Manual De Instrucciones

PM725.manual 5/27/08 9:23 AM
Code Learning, Cont.

LEARNING COMMANDS

1. P ress and hold the Code Search button until the re d
i nd icator stays on. Release the Code Search button.
2. Press the mode button for the type of device
you want to learn (TV, VCR, Cable, etc.).
The indicator lights blinks off once.
3. Press the Learn button.
4. Press the button on the Learning Remote that
you want to teach, e.g. Power.
5. Point both remotes at each other (see tips on
page 11). Press and hold the Original Remote
button that you want to learn, e.g. Power, until
the indicator light turns off. If there is a problem
with learning, the indicator light blinks for three
seconds but the remote remains in the Learning
mode. If this happens, repeat from Step 4.
6. Repeat Steps 4 and 5 for other buttons you want
to learn.
7. Press and release the Code Search button when
all desired original remote commands are learned.
Code Learning is now complete.
Note: No functions may be stored under the
Code Search button, any mode button, AUX button,
or the Learn button.
5.
Aprox. 1 inch apart
2.
1.
1 4
Page 14
4.
3.
Code Learning, Cont.
TO CLEAR ALL LEARNED COMMANDS UNDER A MODE
1. Press and hold the Code Search button until
the indicator light turns on. Release the Code
Search button.
2. P ress and release the button for the mo de you want
to clear (TV, VCR, etc.). The ind icator blinks of f .
3. Press and release the Learn button TWICE.
The indicator blinks off.
4. Press and release Code Search.
The indicator blinks off.
All learned Comma nds under that mo de are now cleare d.
2.
1,4.
MASTER CLEAR - TO CLEAR ALL LEARNED
COMMANDS, I.E. RETURN TO FACTORY DEFAULTS
1. Press and hold the Code Search button until
the indicator light turns on. Release the
Code Search button.
2. Press and release the Learn button TWICE.
The indicator blinks off.
3. Press and release Code Search.
The indicator blinks off.
All Learned comma nds in the re mote are now cleare d.
1.,3.
3.
2.
1 5