Turning Off; Power Saving Function - Dockin D Fine+ Manual De Instrucciones

TURNING OFF

Press the button on the top side of your D FINE + and hold for 3
seconds to turn off.
Connecting your D FINE + to your device using the 3.5mm AUX cable.
Startup:
1. Connect your device using the provided 3.5mm stereo cable to
the AUX input of your D FINE +.
2. Start playback on your device.
The D FINE + power saving mode is disabled, when an AUX cable is
connected. When both AUX cable and Power In are connected your
D FINE + can be used stationary, e.g. as a PC speaker or TV sound-
STEREO LINK FUNCTION
Pair two Dockin D Fine +:
1. Connect your Bluetooth playback device to one of the speakers
the usual way (see above)
2. Press the -button twice on both speakers. This will enter ste-
reo link mode.
3. After a short time both units will be paired and a confirmation
sound can be heard. The left channel will have a higher pitched
sound playing after the initial confirmation for identification.
4. Start the music on the playback device. Both D FINE + speakers
will play back sound now.
6
The controls and volume changes are applied to both devices in Ste-
reo Link Mode.
The pairing information is stored. This will automatically reconnect
the speakers the next time they start up. The left / right assignment
is saved as well.
By pressing the Power button twice on one of the two D FINE + the
Stereo Link Function is disabled and playback is continued with only
one speaker.
CHARGING
Charge your D FINE + by using the provided power cable. The
charging input is located behind the cover on the side.
20% 50% > 50%
During charging the LED is green. Once the device is completely
charged, the LED turns off.
Only use the supplied power supply unit to charge the device.
Device ID: DYS40-150240W-K

POWER SAVING FUNCTION

If there hasn't been any signal transmission or charging via the USB
output for 15 minutes, your D FINE + turns off automatically. If the
AUX cable is connected the power saving function is disabled, which
allows stationary use.
7