NORTH STATES 8620 Instrucciones página 4

HARDWARE MOUNTED
Used where additional security is required (top of the stairs etc.).
Warning:
DO NOT MOUNT HINGES INTO SHEETROCK OR PLASTER. HARDWARE IS
INCLUDED FOR USE IN SOLID MATERIALS ONLY, SUCH AS WOOD OR METAL.
STEP 1
Hold the gate so the locking handle is on the opposite side of the area accessible to the child
and determine on which side you want the gate hinges.
STEP 2
Slide both gate hinges onto the hinge side of the gate and fasten lower hinge with smaller
screw provided (do not fasten top at this time).
STEP 3
Fasten both the casement hinges to the doorway using the longer screws provided. Mount
upper casement hinge with hinge facing down, mount lower casement hinge with hinge
facing up.
STEP 4
Determine the direction you desire the gate to swing.
Gate to swing towards you—place bottom gate hinge onto bottom casement hinge
using the hole in the hinge that is closest to you.
Gate to swing from you—Use the hole in the gate hinge furthest from you.
DO NOT ALLOW GATE TO SWING OVER THE STAIRS.
STEP 5
Slide the gate hinge on the top of the gate up to the casement hinge and fasten the top
gate hinge with the small screw provided.
STEP 6
Place tape pads in recessed area of door or rail sockets.
STEP 7
Remove protective cover sheet from one of the sockets and with "U" upright, place on a flat, even
surface 3" above the floor measured from the bottom of the socket.
Mount second socket 23" (measured from the bottom of the sockets) above bottom socket.
Screws, in addition to tape pads, may be used for added security. Use two longer screws provided.
Warning:
SCREWS ARE REQUIRED IF GATE IS INSTALLED OVER THE STAIRS.
OPERATION
To close the gate: Expand gate so the 2 bumpers fit in the sockets. Rotate locking handle and insert
handle tab into the slot that gives you enough tension to secure the gate.(see figure 2)
To open the gate: Lightly press down on the locking handle, twist handle outward and pull gently
away from the gate. Slide gate together and swing open.
CLEANING INSTRUCTIONS: Wash with warm water using mild liquid soap. Use a soft cloth to avoid
scratching the gate. Rinse with clear water and wipe dry with a soft cloth. NOTE: Never use solvents,
chemicals, scouring powders and sharp tools when cleaning the gate.
Page 4
SLIDE GATE HINGE
PAST MOUNTING HOLE
WITH TAB ORIENTATED
AS SHOWN (DO NOT
FASTEN AT THIS TIME)
DRILL / " (1.59mm)
1
16
PILOT HOLES
23
3 /8"
(60cm)
MOUNT IN THIS
22
5 /8" HOLE FOR GATE
TO SWING
TOWARD YOU
MOUNT IN THIS
HOLE FOR GATE
TO SWING AWAY
3
3 /4"
4
1 /2"
Figure 9
Figure 8