Chair Assembly
1
Connecting the chair back to the support tube
Align the two metal sheets (DD) preassembled to the support tube (D), over the four holes in the bottom of the chair back (C).
Attach the bottom of the chair back (C) to the support tube (D) with M8x37 hex bolts (AA), M8 washers (FF), and M8 plastic washers (II)
through a metal sheet (DD), the chair back (C), and the support tube (D). The heads of the bolts should face the chair seat.
Secure by attaching M8 washers (FF), M8 spring washers (GG), and M8 nuts (HH) to the ends of the M8x37 hex bolts (AA).
NOTE: Loosely tighten the bolts using the wrench (JJ).
HH
GG
FF
C
DD
II
FF
AA
D
5
Please contact 1-877-527-0313 for further assistance.
C
D
HAMPTONBAY.COM