Completing Installation - Heath Zenith 6115 Manual Del Usuario

CAUTION: Do NOT connect the motion
switch to house NEUTRAL (white wire).
IMPORTANT: When sliding the control
switch from OFF to AUTO, there is a 1
minute warm up period before the control
will become fully functional.
IMPORTANT: In AUTO mode, if the sensor
turns the light off, there is an 8 second
delay before the sensor will turn the lights
on when motion is sensed.
ADJUSTMENTS
There are preset selections for the amount of time
the lights stay on: Test (30 seconds), 5, 10, 20, and
30 minutes. Use a small, phillips screw driver to
adjust the TIME control (see Figure 4). Turn the
TIME control until it "snaps" into the desired time
position (arrow determines position).
LIGhT SENSITIvITy LEvEL
You can adjust the sensor's sensitivity to existing
light. Use a small phillips screwdriver to adjust
the LIGHT control (see Figure 4). By turning the
control fully clockwise (arrow determines position),
the sensor will turn lights on even in full daylight.
By turning the control fully counterclockwise, the
sensor will only turn lights on when the existing
light is very low.
1. When the existing light in the room is at the
level you want the lights to turn on, set the mode
selection switch to the AUTO position.
2. Adjust the TIME control to the 5 minute posi-
tion.
3. Adjust the LIGHT control to the minimum dark
position (fully counterclockwise).
4. Wait for the lights to turn off.
5. Slightly turn the LIGHT control clockwise. Wait
2 seconds, then move your hand in front of the
598-1372-01
TIME
sensor. If lights controlled by the sensor do not
come on, repeat this step until they do. The light
will now come on when the light level is at or
below the present level and motion is detected.
10
5
5
Test 30
T I M E
Figure 4 - Control Panel

COMPLETING INSTALLATION

1. Replace control panel cover and attach the deco-
rative wall plate (see Figure 2). In installations
where the motion sensor switch is combined
with other switches or outlets on an expanded
box, you will need to purchase a combination
wall plate. Various combination wall plates are
available at home centers and electrical supply
stores.
2. Slide the mode selection switch a couple times
to make sure it moves freely.
MODE SELECTION SWITCh
This switch allows you to select one of three modes
of operation: OFF, AUTO, or ON.
OFF: Lights stay off.
AUTO: Lights automatically come on when mo-
tion is detected and the existing light is below
the set level.
ON: Lights stay on continuously.
IMPORTANT ThINGS TO REMEMbER
• The motion switch will sound a low audible click
when motion is detected.
• The switch will activate only if the motion switch
is in AUTO mode and the ambient light is below
the set LIGHT level.
• Itisrecommendedtousethesettingof10minutesor
greater when using fluorescent and CFL lighting.
3
+
20
L I G H T