Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Make sure to set the AC power adaptor to the correct voltage
(110VAC/220VAC) using the voltage selector switch
2.
Connect the AC power adaptor to the power source near where you
wish to setup your speakers.
3.
Connect the AC power adaptor to the input jack on your speakers
(DV 12V).
4.
Insert the RCA cable from the first speaker to the second speaker in
the "Input" audio jack.
5.
Connect the stereo 3.5 mm cable to the "Line Out" jack on your
computer's audio card (usually labeled green) or to the 3.5 mm audio
output on your audio device.
6.
Twist the dial on the speakers clockwise in order to power your
speakers on.
7.
This same dial can be used in order to control the volume level of
the speakers. Turn it clockwise or counter-clockwise according to your
needs.
8.
When you wish to power your speakers off, twist the dial
counter-clockwise.
If you will not be using your device for an extended period of time,
disconnect the AC power adaptor from the power source.
INSTRUCTIONS
ENGLISH-07
Publicidad
Tabla de contenido
