Operation - oneConcept Heat Spike Manual De Instrucciones

OPERATION

1. Carefully remove the heater from the plastic bag and the carton.
2. Place the heater on a firm level surface,.
3. Setting the master button to "off", on the base of the unit, plug the cord
set into a 220-240 V~AC electrical outlet.
4. Plug in, Switch the power point to the on position then turn the master
button on the heater to the on position, the heater in standby mode,
LED display room temperature, centigrade light, Please wait 3 seconds,
then start to operate any function, after 30 seconds, if no operation,
light and LED switch off.
5. Turn the heater ON by pressing the ON/OFF button
in fan mode. This will conduct recirculation of the room air.
Upon pressing the "I/II" button the unit will be in the LOW
1200 W rating power.
Pressing the "I/II" button second time will put the heater into HIGH
mode, it's 2000 W rating power, low and high indicator light together.
6. To turn the heater OFF, press the ON/OFF button
NOTE: To assist in maintaining the internal components, after pressing the
"ON/OFF" button, the fan will continue to blow room air for a period of 30
to 60 seconds before shutting down to standby.
Osciallation button
This heater has an oscillating function. To switch the function on, press the
SWING button. To stop it, press the oscillating button again.
WARNING: Danger of scalding
Before removing the plug from the socket, switching off and better
work for 30-60 second for cool down in condition that protecting
inner parts.
Timer function
This function will work in any mode. The timer function allows you to set
the length of operation from 1 to 8 hours.
To set the timer, press the TIMER button. The display screen will show
1h, indicating the heater will operate for 1 hour before shutting down to
standby. To increase the operation time, continue to press the "+" button
.The unit is now
heat mode. It is
heat
.
EN
21