EN
24
BEFORE FIRST USE
• Before use, remove all packing materials, including bottom cushions, foam pads
and tapes inside of the refrigerator; tear off the protective film on the doors and the
refrigerator body.
• Keep away from heat and avoid direct sunlight. Do not place the freezer in moist or
watery places to prevent rust or reduction of insulating effect.
• Do not spray or wash the refrigerator; do not put the refrigerator in moist places
easy to be splashed with water so as not to affect the electrical insulation properties
of the refrigerator.
• The refrigerator is placed in a well-ventilated indoor place; the ground shall be flat,
and sturdy (rotate left or right to adjust the wheel for levelling if unstable).
• The top space of the refrigerator shall be greater than 30 cm, and The refrigerator
should be placed against a wall with a free distance more than 10 cm to facilitate
heat dissipation.
• Before initial start, keep the refrigerator still for half an hour before connecting it to
power supply.
• Before putting any fresh or frozen foods, the refrigerator shall have run for 2-3
hours, or for above 4 hours in summer when the ambient temperature is high.
• Spare enough space for convenient opening of the doors and drawers.
CONTROL PANEL
A = Temperatur Control of the fridge
B = Power Cool / Locking / Unlocking
The control panel is 100% lit up for 3 seconds, which
operates exactly as per the setting (mode and
temperature) before the power off. The system will be
automatically locked 2 seconds after the last
key operation. After locking, the light of the panel
would be off 1 minute after the last key operation.
Both preset temperatures of fridge compartment would
be shown on the display.
The panel will be lit up once the door of fridge
compartment or freezer compartment is opened. The
panel will be lit up by any key operation whereas the
light would be off 1 minute after the last operation.
Display during normal operation Temperature Display
of the Fridge Compartment: Indicating the temperature
of the current setting.