Silverline 304583 Manual Del Usuario página 7

304583
Accessories
• A full range of material specific saw blades, plunge cutting blades and other
accessories is available from your Silverline stockist
Maintenance
WARNING: ALWAYS ensure that the tool is disconnected from the power supply,
before cleaning, changing accessories, or carrying out maintenance.
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate loose
over time
• Inspect the supply cord of the tool, prior to each use, for damage or wear.
Repairs should be carried out by an authorised Silverline service centre. This
advice also applies to extension cords used with this tool
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection and gloves
when cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear
quickly, and shorten the device's service life
• Clean the body of your machine with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, a
mild detergent on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the ventilation holes
(where applicable)
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or
visible sparking
• To replace the brushes, remove the brush access plugs from both sides of
the machine. Remove the worn brushes and replaced with new. Replace
brush access plugs. Alternatively, have the machine serviced at an authorised
Silverline service centre
Note: The brush access caps are located on the Rotating Barrel (5). The Handle
(8) must be adjusted to the most outward positions to gain brush access (see
'Adjusting handle position').
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no
longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way
to dispose of power tools
800W Reciprocating Saw
www.silverlinetools.com
7