Intended Use - Porter Cable PCC795 Manual De Instrucciones

2. For long storage, it is recommended to store a fully
charged battery pack in a cool dry place out of the
charger for optimal results.
nOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
SAVE THESE
INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)

WARNING:
or any part of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.

INTENDED USE

The vacuum is designed to operate only on a
PORTER-CABLE 20V Max* Li-Ion battery pack. Battery pack
and charger are sold separately.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
The vacuum is designed to perform as a wet/dry unit
with no component changes required when changing
from wet to dry, or dry to wet pick up. This vacuum is for
household use only.
It is recommended that the tank be emptied of any dry
contents prior to being used for wet pick up to facilitate
tank cleaning.
THIS PRODUCT USES THE BATTERY
AND CHARGER LISTED IN THE CHART
BELOW.
Description
20V Max* lithium-ion
Battery:
20V Max* lithium-ion
Battery Charger:
ASSEMBLY AND ADJUSTMENTS

WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
Never modify the power tool
Catalog Number
ʵ PCC680L
ʵ PCC681L
ʵ PCC682
ʵ PCC682L
ʵ PCC685L
ʵ PCC690L
ʵ PCC691L
ʵ PCC692
ʵ PCC692L
ʵ PCC695L
To reduce the risk of
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Attaching vacuum hose (Fig. B)
The vacuum hose will need to be attached to the
8
vacuum before using the appliance.
1. Place the vacuum on a flat, firm surface.
2. Unlatch tank latches
5
the tank. Remove the hose
3. Align the hose end 13
front of the appliance, ensuring the hose alignment lock
14 is aligned with the arrow
4. Insert the hose end into the intake port and twist
clockwise to lock in place.
5. Replace power head onto the tank and secure latches.
nOTE: The power head will only fit onto the tank when the
intake port on the front of the power head and the storage
area for the wide nozzle tool on the tank are aligned as
shown in figure B.
Fig. B
15
14
13
OPERATION

WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Installing and Removing the Battery
Pack (Fig. C)
nOTE: For best results, make sure your battery pack is
fully charged.

CAUTION:
terminals are dry and clean before installing battery
pack.
To install the battery pack
the battery pack with the rails inside the tool's battery port
until the battery pack is firmly seated in the tool and
7
ensure that it does not disengage.
English
and remove power head from
from the tank.
8
with the intake port 6 on the
15 on the intake port.
To reduce the risk of
Ensure battery port and
into the power head, align
16
7