Protecting The Environment - DeWalt DE0881 Traducido De Las Instrucciones Originales

e. Foot
f. Mounting thread
g. Locking collar
h. Elevator column
i. Elevator lock knob
j. Bubble level
INTENDED USE
Your tripod has been designed for to extend the
capabilities of your laser. The tripod helps to position
the laser on rough, out-of-level surfaces. The tripod
can be used both indoors and outdoors.
DO NOT let children come into contact with the
attachment or laser. Supervision is required when
inexperienced operators use this attachment.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: Refer to the laser manual to
be used with this attach.
Bubble Level
Use the bubble level (j), located under the rotary
head mount (a), to ensure the tripod is level..
Tripod Setup
1. Spread the legs (c) apart to install the tripod in
upright position.
2. Tighten the locking collar (g).
3. Adjust the legs (c) if required so that each of the
feet (e) is firmly touching the ground.
4. Mount the laser on the tripod.
Adjusting the Leg Height
1. Release the quick-adjust latch (b) of the first leg
(c) to set the desired height. Tighten the latch.
2. Repeat process for the other legs.
Mounting the Laser to the Tripod
The tripod has been equipped with a threaded pin
for mounting of the DW088 and DW089 lasers.
1. Install the tripod on a relatively smooth and level
surface, using the bubble level (j) as a guide.
2. Mount the laser to the tripod by turning the
mounting thread (f) into the receptable in the
base of the laser.
WARNING: Before mounting a laser to
the tripod, check that the legs are firmly
set and that the tripod is wobble free
Elevating the Head Mount
The head mount (a) can be elevated to a maximum
height of 1.7 m. The laser is operated using the
elevator crank handle (d). Move the head mount
to the desired height and tighten the elevating lock
knob (i).
Storage
In order to conveniently store the attachment, a
carrying bag is included.

Protecting the Environment

Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D WALT products once they have
E
reached the end of their working life. To take
advantage of this service please return your product
to any authorised repair agent who will collect them
on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your local
D WALT office at the address indicated in this
E
manual. Alternatively, a list of authorised D
repair agents and full details of our after-sales
service and contacts are available on the Internet at:
www.2helpU.com.
EN G LI SH
WALT product
E
WALT
E
11