Installation; Making The Electrical Connections - Defiant 51401141 Manual De Uso Y Cuidado

installation

warninG: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off
the circuit breaker before removing the existing light fixture or installing the new one.
With power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current
fixture is wired (by wire color) or mark the wires with masking tape and a pencil so you will know how to properly
reconnect the wires to the new LED light fixture.
1
Attaching the mounting bracket to
the electrical box
□
Attach the mounting bracket (FF) to the electrical
box using the two short mounting screws (BB). The
stamped word "GND" faces away from the electrical
box during the installation.
2
Attaching the
foam gasket to the
electrical box
□
Position the foam gasket
(GG) between the electrical
box and the back of the light
fixture base (B) to create a
weathertight seal.
□
Pull the wires from the
electrical box through one of
the two openings in the foam
gasket (GG).
3
Making the electrical
connections
□
Connect the hot and neutral (black and white)
wires from the light fixture base (B) to the same
color wires from the electrical box.
□
Connect the ground wire from the light fixture
base (B) to the ground wire from the electrical
box, then attach the ground wire to the
grounding screw (CC) on the mounting bracket
(GG).
□
Cover the wire connections using the wire
connectors (EE).
B
FF
GG
GG
CC
4
GG
EE
B
BB
FF
FF