ESAB M3 plasma Vision 50P Manual De Instrucciones página 64

第二章
2.9. 7 选择导入方式 （继续）
One should be careful also to check for the kerf offset when cutting very small holes. The
在切割很小的孔时， 要不停地检查切缝偏移。 垂直导入的角度必须修正以使起弧位置在孔的中心。 忽视这一偏移
angle of the straight lead in will have to be modified to allow the start position to remain
可导致等离子在孔边缘或边缘的外面开始切割。
in the center of the hole. Ignoring this offset can lead to the plasma starting on the edge or
outside the edge of the hole.
Make sure the plasma starts in the center of the hole.
• 确保等离子在孔的中心开始。
Make sure the plasma torch is at the correct height before it reaches the edge of the
• 在到达轮廓边缘前， 确保等离子割炬在正确的高度。
contour.
• 确保进给速度是正确的。
Make sure the feed rate is correct.
• 按照前两个例子中的任何一个来结束切割并使孔有最小变形。
Follow either of the previous two examples to end the cut with minimal deformation to
the hole.
Vision 50P CnC与接口箱
64