Camera Setup; Fine Tuning; Night Vision; Monitor Setup - Nannio Eye Manual Del Usuario

Setup
1

Camera Setup

1
Power Supply - Using AC Power
.1
1. Plug one end of the provided power adapter into a wall outlet and the other
end into the side of the camera (See Fig. 3).
Note : Use the Micro USB adapter labeled OUTPUT: 5V 1A for the camera.
2. Slide the POWER button
camera will light up (green light) (See Fig. 3).
1
.2

Fine Tuning

Place the camera in a convenient location, point the lens toward the observation
area and adjust the angle by rotating the lens head (See Fig. 4).
Fixing the camera
You can use the tripod to adjust the angle of the camera(See Fig. 4).
1

Night Vision

.3
The camera has eight high-intensity LEDs for picking up clear images in the
dark. When the light sensor detects low ambient light levels, the LEDs will be
automatically activated.
2

Monitor Setup

2
.1 Power Supply
The monitor uses 3.7V 2600mAh (Li-ion) battery or the household AC power
current.
Changing the Battery
1. Open the battery compartment cover on the rear of the monitor. (See Fig. 5).
2. Pull out the battery and remove the cable. Re-attach the cable with a new
battery (See Fig. 5) .
3. Close the battery compartment cover, and make sure it is locked securely.
4. Press the POWER button
monitor on (See Fig. 5).
Note 1: When power is sufficient, the "Power/Charging" LED will light up
2
(green light); When battery is low, the red LED light will start blinking.
to turn on the camera. The LED on the
and keep it around 3 seconds to turn the